How to operate Seiko kinetic watches or Seiko kinetic auto relay watches.
How to operate Seiko
kinetic watches or Seiko kinetic auto relay watches.
charge Seiko kinetic watches.
Seiko kinetic watches must be charged before they are set. To charge a kinetic watch simply swing the watch in a small arc from side to side for 2 to 3 minutes. As you swing the kinetic watch the oscillating weight in the generating system may give out a small sound as it rotates. When the second hand on the Seiko kinetic watch begins to move in one second intervals, the kinetic watch has stored at least 3 hours of power and is ready to be set.
Checking the power reserve on kinetic watches.
The power reserve indicator shows how much energy is stored in kinetic watches. To check how long a kinetic watch can operate on its current charge, wait until the second hand is in the 12 o’clock position and press the button at the 2 o’clock position on the watch case. Use the chart below to determine how much stored energy is indicated by the number of seconds that the second hand moved. The kinetic watches second hand will resume normal function in 30 seconds or less.
Low reserve warning on kinetic watches.
When the second hand on a kinetic watch starts to move in 2 second intervals instead of the usual one second interval, the watches energy reserves are low. The kinetic watch should be recharged by gently swinging it in a small arc for approximately 1 minute.
Kinetic auto relay
watches advanced features.
auto relay watch features.
· Automatic power generator.
· Automatic energy saving function.
· Manual energy saving function.
· Time relay function.
· Energy depletion warning function.
Kinetic auto relay watches automatic energy saving function.
If the kinetic auto relay watch is left untouched for 3 consecutive days the hands on kinetic auto relay watches stop moving in order to save energy, while the advanced integrated circuit (IC) continues to keep track of the time.
Kinetic auto relay watches manual energy savings.
You can activate the manual energy saving function on Seiko kinetic auto relay watches by pulling the crown out to the first click position and pushing it back in to its normal position in less then a second.
Warning : Do not pull the crown out to the second click position while the energy saving function is in operation. This will cause the time data stored in your Seiko kinetic auto relay watch to be erased thus disabling the time relay function.
Seiko kinetic auto relay watches time relay function.
The time relay function automatically resets the watch hands to the correct time when the watch is reactivated after being in the energy saving function mode in which the hands don’t move. The correct time is relayed from the IC to the hands which begin to move again.
To activate your Seiko kinetic auto relay watch simply swing it gently. This generates electricity which automatically activates the time relay function and the hands on Seiko kinetic auto relay watches are adjusted to the proper time retained inside the watch’s IC. If the kinetic auto relay watch is fully charged when the power saving function is activated the time relay function remains operable for approximately 4 years.
Energy depletion warning function on Seiko kinetic auto relay
As with all Seiko kinetic & Seiko kinetic auto relay watches, when the second hand starts to move in 2 second intervals, the watches energy reserves are low. The Seiko kinetic or kinetic auto relay watch should be charged by swinging it side to side in a small arc for approximately 1 minute.
|||Home || Contact Us || Casio || Timex || Bulova || Swatch || Nike || Suunto || Seiko || Citizen ||.|